Celestron StarSense Explorer DOB 114 MM Kurzanleitung Zur Einrichtung Seite 6

10
G
10. Install the StarSense dock (G). Insert the bayonet mount
on the side of the dock into the port on the side panel of the
base.
12a
H
For the 114mm model:
12a. Install the StarPointer red dot finderscope (H) onto the
optical tube assembly. First, unthread and remove the two
thumbnuts from the threaded posts adjacent to the focuser.
Place the StarPointer on the tube so the threaded posts go
through the holes in the StarPointer's base, then rethread
the thumbnuts onto the posts to secure the StarPointer.
6 | ENGLISH
11
G
11. Line up the arrow on the dock with the alignment mark
on the base and press inward while turning the dock
counterclockwise until the orange release button snaps into
place in the hole on the dock. To remove the dock, press the
orange release button and turn the dock clockwise until the
bayonet mount releases.
12b
H
For the 130mm and 150mm models:
12b. Install the StarPointer red dot finderscope (H) onto the
optical tube assembly. First, loosen the thumbscrew on the
finderscope holder. Insert the base of the StarPointer into
the holder and tighten the thumbscrew.