Celestron StarSense Explorer DOB 114 MM Kurzanleitung Zur Einrichtung Seite 5

8
1
F
8. Install the eyepiece rack (F1) by placing the keyholes in the
rack over the mounting screws pre-installed in the side panel,
then push the rack downwards.
NOTE: If you want to remove the rack for storage or transport,
simply pull it upward.
9b
A
For the 130mm model:
9b. Loosen the knob on the dovetail holder on the side panel.
Then, insert the dovetail connected to the optical tube with
the tube rings, and retighten the knob until the dovetail is
secure in the holder.
9a
For the 114mm model:
9a. Connect the optical tube assembly (A) to the assembled
base.Fully unthread the clamping knob on the cradle and
open the cradle. Place the optical tube in the cradle as
shown, close the cradle, and retighten the clamping knob
until secure.
9c
A
For the 150mm model:
9c . Connect the optical tube assembly (A) to the assembled
base.You'll need to connect the tube rings to the tube
ring mounting plate on the base. Use the screws and lock
washers already installed in the rings to do this. It will be
easiest to fi rst remove the rings from the optical tube to
assemble them onto the mounting plate. Fully unthread the
tube ring knobs and open the rings to remove the tube.
A
ENGLISH | 5