Celestron StarSense Explorer DOB 114 MM Kurzanleitung Zur Einrichtung Seite 3

Assembly
1a
B 1
2
B
For the 114mm and 130mm models:
1. Connect the side support (B2) to the side panel (B1) with the
base assembly screws (B5). The supports go on the on the
same side of the panels as the Celestron logo.
2
6
B
6
B
2. If desired, you can install the cosmetic screw covers (B6) on
the screws installed in Step 1. Press the covers fi rmly onto the
screw heads. For the 114mm and 130mm models there will
be 2 screw covers to install, for the 150mm model there will
be 6 screw covers to install.
1b
5
B
2
B
For the 150mm model:
1a. Connect the 2 side supports (B2) to the side panel (B1) with
the base assembly screws (B5). The supports go on the on
the same side of the panels as the Celestron logo.
3
3
B
3. Connect the assembly to the top plate (B3) using the base
assembly screws (B5). Orient the top plate so the side with
the logo faces upward. For the 114mm model there will be 4
screws to install, for the 130mm and 150mm models there will
be 5 screws to install.
1
B
5
B
5
B
ENGLISH | 3