Celestron StarSense Explorer DOB 114 MM Kurzanleitung Zur Einrichtung Seite 4

4
C 1
4. Attach the 3 tripod adapter discs (C1) to the bottom plate (B4)
using the tripod adapter screws (C2). Thread the screws fi rmly
into the predrilled pilot holes but do not overtighten or you may
strip the wood.
6
6. Connect the assembly to the bottom plate (B4). Place one
of the steel washers (E2) and the plastic cylinder (E4) onto
the bolt (E5). Then, insert the bolt through the central hole in
the bottom plate. Next, place the Teflon washer (E3) over the
plastic cylinder (E4) now protruding from the bottom plate.
Take the assembled base and lower it onto the bottom plate so
that the plastic cylinder goes through the central hole in the top
plate. Now, place the remaining steel washer (E2) on the end
of the bolt protruding from the top plate. Thread the nut (E1)
onto the bolt. Go to Step 7 for instructions to tighten the bolt.
4 | ENGLISH
4
B
2
C
1 1
E E
1 2
E E
E 3
B4 B4
4
B
4
E
2
E
5
E
5
B
D 1
2
D
3
D
5. Attach the 3 feet (D1) to the bottom plate (B4) using the feet
screws (D2). Thread the screws fi rmly into the predrilled pilot
holes. Once installed, press the feet screw covers (D3) onto
the ends of the feet.
7
7. Use the crescent wrench and large hex key to tighten the nut
onto the bolt. Hold the head of the bolt stationary with the hex
key while using the crescent wrench to tighten the nut. DO
NOT OVERTIGHTEN THE NUT! With some force, you should
still be able to move the steel washer underneath the nut with
your fi ngers. If the washer cannot be moved with your fi ngers,
slightly loosen the nut.
4