Digital Operation, Operation With Mts; Connections To The Multi-Train Control; Operation With The Multi-Train System - LGB Lokhandy 55016 Handbuch

Digital Operation, Operation with MTS

Connections to the Multi-Train Control

There is a connecting cable with a rectangular Western
Electric plug on the end on the Handheld Locomotive
Controller. This Western Electric plug goes into the
socket marked LGB-Bus on the MTS central unit.
The battery holder in the Handheld Locomotive Control-
ler is only for radio operation with the LGB 55050/55055.

Operation with the Multi-Train System

After you have connected the Locomotive Hand Cont-
roller, (xx = locomotive address) will appear in the
L x x
display for the last locomotive used.
Selecting the locomotive address:
• Press the button. The display will show
0
• Enter a two-digit locomotive address (00 – 22).
• The new locomotive address will appear on the
display, example:
L 3
• If the locomotive address selected is in use by ano-
ther control device, the upper monitor light will not
light up (does not apply to radio operation).
Such a locomotive cannot be controlled until it is re-
leased from the other controller. To do this, the other
controller must be at zero for about 4 seconds with
this locomotive.
• When an invalid address is entered, the display over-
rides automatically
L - -
L - -
.
.
.
11