Use; Unwind The Mains Cable; To Switch On And Off; To Regulate The Suction Power - Miele COMPACT C2 Gebrauchsanweisung

^ Attach the accessories holder to the
suction hose where it joins the handle
or to the hose connecter socket on
the vacuum cleaner. Make sure it
clicks into position.
Certain models are supplied as
standard with the following accessories
which are not illustrated on this page.
– Classic Allergotec floorhead
– Turbobrush
These floorheads and brushes are
supplied with their own operating
instructions.
Floorhead (dia. 18)
For general use and also for vacuuming
the stairs.
,
For safety reasons when
vacuuming stairs it is best to start at
the bottom of the stairs and move
upwards.

Use

Unwind the mains cable (dia. 19)
^ Pull the mains cable out to the
required length (max. cable length
approx. 6.5 m).
^ Insert the plug into the socket
correctly and switch on.
,
If vacuuming for longer than 30
minutes, the mains cable must be
pulled out to its fullest extent.
Otherwise there is a danger of
overheating and damage.
To rewind the cable (dia. 20)
^ Switch off at the wall socket and
remove the plug.
^ Press the rewind foot switch briefly.
The cable will rewind automatically.
To switch on and off (dia. 21)
^ Press the On/Off foot control s.
To regulate the suction power (dia.
22)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to
manoeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
# - curtains, fabric
$ - upholstery, cushions
% - thick pile carpets, rugs and
runners
* - for energy-saving vacuuming
(this setting is also very quiet)
( - loop pile carpet
) - heavily soiled hard flooring
and intensive cleaning of carpets
When using the AirTeQ floorhead, if
the suction seems too high, reduce
the suction until the floorhead is
easier to manoeuvre.
^ Turn the suction power selector
manually to the suction power setting
you require.
en
35