Intended Use - Makita JR002GZ01 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Length of stroke
Strokes per minute
Max. cutting capacities
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for sawing wood, plastic and fer-
rous materials.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-11:
Sound pressure level (L
Sound power level (L ) : 98 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be
used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual use
of the power tool can differ from the declared value(s)
depending on the ways in which the tool is used espe-
cially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is run-
ning idle in addition to the trigger time).
Pipe
Wood
with BL4025
with BL4050F
) : 87 dB(A)
pA
D.C. 36 V - 40 V max
BL4020* / BL4025* / BL4040* / BL4050F* / BL4080F
* : Recommended battery
DC40RA / DC40RB / DC40RC
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-11:
Work mode: cutting boards
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: cutting wooden beams
Vibration emission (a
Uncertainty (K) : 1.8 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during
actual use of the power tool can differ from the
declared value(s) depending on the ways in which
the tool is used especially what kind of workpiece
is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
4 ENGLISH
JR002G
32 mm
-1
0 - 3,000 min
130 mm
255 mm
436 mm
473 mm
4.6 - 5.8 kg
2
) : 8.5 m/s
h,B
2
2
) 7.9 m/s
h,WB
2