Inhaltsverzeichnis
Werbung
Removing the blades
Before removing the blades, check their instal-
lation position!
1. Unscrew and remove the hexagon bolt (1).
2. Carefully pull the ball bearing (2) off the shaft (8).
3. Pull the thrust ring (3), washer (4) and short
spacer tube (5) off the shaft.
4. Pull off the blades (6) and long spacer tubes one
after another.
Install in the reverse sequence.
Help in case of malfunctions
Malfunction
Help
Check the power cable and
Motor does not
„
the residual-current circuit
run
breaker
Push the operator presence
„
control towards the top
handlebar.
Select a lower working depth.
„
Select a lower working depth.
Shaft does not
„
rotate
Clear the blades.
„
Contact a customer service
„
workshop.
Select a lower working depth.
The motor is
„
losing power
Renew worn blades.
„
Clean the housing.
„
Mow the lawn (grass is too
„
long).
Select a lower working depth.
Poor scarifying
„
performance
Renew worn blades.
„
Damaged blades.
Machine is
„
not running
Contact a customer service
„
smoothly
workshop.
Machine is
vibrating
Malfunctions that cannot be rectified using this table
must be attended to by an authorised specialist work-
shop.
16
(Fig. I)
Disposal
Do not dispose of worn-out machines or
spent batteries (including rechargeable
batteries) in domestic waste!
The packaging, machine and accessories are made
from recyclable materials and must be disposed of
accordingly.
Translation of original user instructions
Werbung
Inhaltsverzeichnis
