Initial Setting; Functional Description; Parts Description - Makita DG001GM105 Betriebsanleitung

INITIAL SETTING

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.

PARTS DESCRIPTION

► Fig.1
1 Main tool
3 Side handle
5 Bit adapter
7 Bolt
Specifications of the bolt / wrench
- Nominal diameter
A
B
C
NOTE: The type of the bit adapter varies depending
on the country.
Setting up the tool
CAUTION:
Always be sure that the side
handle and the reaction receiver are installed
securely before operation.
NOTICE:
Do not over tighten the bolts. It may
damage the tool.
Installing the side handle
Remove the bolts shown in the figure from the tool.
The removed bolt is not needed for this tool if you want
to use this tool as a cordless earth auger.
Keep the bolts so that they are not lost.
► Fig.2: 1. Bolt
Place the side handle on the tool.
Tighten the all four bolts temporarily, and then securely
tighten the bolts using the wrench.
► Fig.3: 1. Side handle 2. Bolt A 3. Bolt B
Installing the reaction receiver
Place the reaction receiver so that the bar of the reac-
tion receiver comes to the left side of the operator.
Adjust the position of the reaction receiver so that the
axis of the drill chuck is in the center of the operator's
body.
Fasten the bolts firmly.
► Fig.4: 1. Bar of the reaction receiver 2. Bolt C
2 Front handle
4 Reaction receiver
6 Chuck key
8 Wrench
Wrench size (H)
of the bolt
M 12 10 mm
M 8 6 mm
M 6 5 mm

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Indicating the remaining battery capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.5: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Tool / battery protection system
The tool is equipped with a tool/battery protection system. This
system automatically cuts off power to the motor to extend tool
and battery life. The tool will automatically stop during operation if
the tool or battery is placed under one of the following conditions:
Overload protection
When the tool/battery is operated in a manner that causes it to
draw an abnormally high current, the tool stops automatically. In
this situation, turn the tool off and stop the application that caused
the tool to become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
8 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have