urmet 1092/219 Bedienungsanleitung Seite 35

Option
AREA SEL.
AREA STATE
HEIGHT
WIDTH
LEFT/RIGHT
TOP/BOTTOM
DEGREE
VIEW
RETURN
AREA SEL – SELECTION OF MOTION DETECTION AREA
Select this option to access the selection display:
In this special screen, the scene is split up into sectors, that can be activated by the user.
Therefore it is possible to make some specific points sensitive to movement (up to 4) and exclude other
ones. For example, if the scene includes a door and a window, the alarm can be activated only by a door
movement, excluding any movement of the window.
Press to the side the button on the camera front panel to select the zone (for example the door) and
confirm by pressing the central button.
To deselect the point, press again the button to the central position.
DS 1092-132
All manuals and user guides at all-guides.com
Value
AREA1 ÷ AREA2 ÷
The scene is split up into areas that can be activated by
AREA3 ÷ AREA4 the user (see below)
Select this option to enable (ON) or disable (OFF) motion
ON ÷ OFF
detection for previously selected areas.
This function allows to define the height of the selected
000 ÷ 013
area.
This function allows to define the width of the selected
000 ÷ 013
area.
This function allows to move horizontally in the monitor
000 ÷ 013
the previously defined area.
This function allows to move vertically in the monitor the
000 ÷ 013
previously defined area.
This function allows to increase or decrease the motion
detector sensitivity.
000 ÷ 013
Use the camera joystick to select a value from 0 (high
sensitivity) and 255 (low sensitivity).
Select this option to activate (ON) or deactivate (OFF) the
ON ÷ OFF
display of the motion detection area.
It allows to quit the submenu.
/
Description
35