Intended Use; Part 2. Installation - involight LEDPAR12HEX Bedienungsanleitung

1.3 Intended use:

LEDPAR12HEX is a static lighting device with decorative light effects. It was developed and designed
for professional use in the field of event technology - exclusively indoors. The device may only be used
by persons with sufficient physical, sensory and mental abilities as well as the appropriate knowledge
and experience. Other persons may only use the device if they are supervised or instructed by a person
responsible for their safety.The device is only approved for AC power, 100-240Volt and 50 / 60Hz power
supply.Light effect devices such as LEDPAR12HEX are sensitive and technically advanced devices that
must be handled with care. Therefore, avoid shocks and violence during assembly / disassembly and the
use of the device.
Install the LEDPAR12HEX only in places that are protected from dust, moisture and excessive heat. The
approved operating temperature must be in the range -5 ° to + 45 ° Celsius and the relative humidity
must not exceed 50% (at + 45 °)! Direct sunlight should be avoided during use and during transport. In
the interests of your own safety and those of others, make sure that there are no cables around.

Part 2. Installation:

Unpack the device and carefully check for damages before using it. Place the unit in a suitable place or
hang it on a suitable crossbar. For suspended installation, the device must be secured with an approved
safety rope. In addition, the mounting bracket must be screwed with the enclosed screws and tightened!
Then connect the device to the mains and, if necessary, connect a DMX cable and connect it to other
devices or a DMX controller. More about DMX or Master / Slave operation also in part 3 and 4.
During installation, provisions of the BGV C1 (formerly VBG 70) and DIN 15560 must be observed!
Authorized specialists may only carry out the installation!
22