Intended Use; Part 2. Installation - involight LEDSTROB350 Bedienungsanleitung

1.3 Intended use:

LEDSTROB350 is a static lighting device with decorative light effects. It was developed and designed for
professional use in the field of event technology - exclusively indoors. The device may only be used by persons
with sufficient physical, sensory and mental abilities as well as the appropriate knowledge and experience. Other
persons may only use the device if they are supervised or instructed by a person responsible for their safety.The
device is only approved for AC power, 100-240Volt and 50 / 60Hz power supply.Light effect devices such as
LEDSTROB350 are sensitive and technically advanced devices that must be handled with care. Therefore, avoid
shocks and violence during assembly / disassembly and the use of the device.
Install the LEDSTROB350 only in places that are protected from dust, moisture and excessive heat. The approved
operating temperature must be in the range -5 ° to + 45 ° Celsius and the relative humidity must not exceed 50%
(at + 45 °)! Direct sunlight should be avoided during use and during transport. In the interests of your own safety
and those of others, make sure that there are no cables around.

Part 2. Installation:

Unpack the device and carefully check for damages before using it. Place the unit in a suitable place or hang it on
a suitable crossbar. For suspended installation, the device must be secured with an approved safety rope. In
addition, the mounting bracket must be screwed with the enclosed screws and tightened! Then connect the device
to the mains and, if necessary, connect a DMX cable and connect it to other devices or a DMX controller. More
about DMX or Master / Slave operation also in part 3 and 4.
During installation, provisions of the BGV C1 (formerly VBG 70) and DIN 15560 must be observed!
Authorized specialists may only carry out the installation!
20