Herunterladen Inhalt Inhalt Diese Seite drucken

Eurolite Ir-7 Remote Control - EuroLite AKKU Bar-4 HCL WDMX Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

12
S
E
T
13
W
i
r
e
14
L
i
m
i
Wireless Setting
From factory, this projector is prepared for wireless data transmission (WDMX). If you wish to de-activate
WDMX control, you can select the function "Wire" – "Off". With the function "Wire" – "On" you can log in
the wireless receiver in to a wireless transmitter, the fixture could now receive the wireless DMX signal.

EUROLITE IR-7 remote control

1
The device must be activated for remote control. For this, under menu item SET,
press the ENTER button to confirm activation.
2
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the rear
side of the remote control. Otherwise operation of the remote control is not possible.
4
If the range of the remote control decreases (10 meters as a
maximum), replace the battery. For this purpose, on the rear
side of the remote control press the small bar with the groove
to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
No.
Key
Function
1
BLACKOUT
2
STROBE
3
SPEED
4
SENSITIVITY
5
%
6
+/-
Function
1
O
7
AUTO
O
O
Function
1
O
8
SOUND
O
O
Control via IR remote
O
n
Default setting: On
O
F
F
O
n
Activate W-DMX
O
F
F
De-activate W-DMX
Default setting: On
O
n
Power saving mode: less bright, yet longer duration
O
F
F
Default setting: On
CAUTION!
not be disposed of with regular domestic waste!
Step 1
Step 2
BLACKOUT
any button
STROBE
+/-
SPEED
+/-
SENSITIVITY
+/-
%
+/-
AUTO/SOUND/
STOBE/
SPEED/
SENSITIVITY/%
+/-
/FADE/
MANUNAL/
/R/G/B/A/UV/W
AUTO
+/-
2
AUTO
SPEED
3
AUTO
STROBE
4
AUTO
%
SOUND
+/-
2
SOUND
SENSITIVITY
3
SOUND
STROBE
4
SOUND
%
Step 3
Description
Blackout
Strobe effect - available for the buttons
AUTO/SOUND/FADE/MANUAL/R/G/B/A/UV/W/0 - 9
Select the desired speed
Internal programs
Microphone sensitivity
Sound controlled mode
Dimmer -available for the buttons AUTO/SOUND/
STROBE/FADE/MANUAL/R/G/B/A/UV/W/0 - 9
Increasing/Decreasing
Internal programms
+/-
Desired speed
+/-
Strobe effect
+/-
Dimmer
Sound controlled mode
+/-
Microphone sensitivity
+/-
Strobe effect
+/-
Dimmer
32/37
00094546, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis