Viscosity Table; Troubleshooting Guide - EINHELL TC-SY 600 S Originalbetriebsanleitung

11. Viscosity Table

Examples of spray materials. Follow the
manufacturer's instructions!
Solvent-borne primers
Solvent-borne paint
Water-borne primers
Water-borne paint
Wood preservatives, stains, oils
Disinfectants
Vehicle topcoats

12. Troubleshooting Guide

Problem
No material exits
from the nozzle
Material drips from
nozzle after spray-
ing
Atomization too
coarse
Intermittent („fl utte-
ring") spray
Coating pattern is
too light and uneven
The paint runs or
sags.
Excessive spray
mist
Anl_TC_SY_600_700_SPK13.indb 24 Anl_TC_SY_600_700_SPK13.indb 24
GB
Possible Cause
Nozzle clogged
Material tube clogged
Max. paint volume control rotated too far
anti-clockwise (-).
Material tube is loose.
No pressure build-up in the container.
Consistency of the material is too thick.
Nozzle is loose.
Nozzle is worn.
Nozzle seal is worn.
Solids in the air cap or nozzle.
Material viscosity too high
Material volume too high
Max. paint volume control turned too far
clockwise (+).
Dirty nozzle.
Insuffi cient pressure build-up in the con-
tainer
Almost all of the material in the container
has been used up.
You moved the paint spray gun too fast ac-
ross the surface you are working on.
You applied too much material.
The gun is held too far away from the object
you are working on.
- 24 -
Draining time in seconds (DIN-sec)
25-30
15-30
25-30
20-25
undiluted
undiluted
20-25
Clean
Clean
Turn clockwise (+)
Insert
Tighten container
Dilute
Tighten
Replace
Replace
Clean
Dilute
Turn the max. paint volume con-
trol anti-clockwise (-)
Clean
Tighten the container
Add more
Move the gun more slowly.
Turn the max. paint volume con-
trol anti-clockwise (-)
Hold the gun closer.
Turn the max. paint volume con-
trol anti-clockwise (-)
Solution
21.06.2023 10:56:23 21.06.2023 10:56:23