COMPATIBILITY LIST
Modell
FIAT Ducato III
FIAT Ducato III
FIAT Ducato III
FIAT Ducato III
FIAT Ducato III
CITROEN Jumper III
PEUGEOT Boxer II
Opel Movano
Vauxhall Movano
*N-XFDUC8 device mounting bracket required
CAUTION
-
The installation of the ZENEC system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect
installation can cause damage to the vehicle and the ZENEC system.
-
Correct functioning can only be guaranteed when you use the ZENEC original accessories included in the kit or optionally available. The ZENEC system and the original
accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the ZENEC system.
NOTE
-
The Z-E3776 is set up for direct use in the Fiat Ducato III, Series 8 and 9 ex works. The settings for the steering wheel remote control and button illumination
can be adjusted for other vehicle models in the setup menu.
-
The original tablet/document holder on the dashboard – if present - is functionally impaired by the installation of the Z-E3776 and cannot be used anymore.
-
To install a Z-E3776 device, the vehicle must be purchased with the (aftermarket) radio installation option.
-
The Z-E3776 is not compatible with vehicles equipped with the original factory device (radio, naviceiver).
-
To provide sufficient antenna signal levels for correct tuner function, the vehicle must be equipped with a high-quality active antenna system (FM/DAB+).
THE KIT INCLUDES
No.
Article
1
Mounting frame
2
Remote control
3
Phillips screws
4
GPS antenna with metal plate and double-sided adhesive pad for mounting
5
USB2.0 extension cable
6
USB3.0 extension cable
7
Bluetooth microphone with mounting accessories
8
LIN bus connection cable (direct LFB connection)
9
24 pin connection cable (4,2, M-Zone, AV-IN)
10
LFB analogue adapter (Key1, Key2 and GND)
11
20 pin connection cable (Mic, CAM / Mview, IR-IN, eCall Mute, Analogue SWC-IN)
12
16 pin ISO-DIN main connection cable
13
Main operating instructions unit
14
FM antenna adapter ISO/DIN
15
External SMA WLAN / Bluetooth antenna
16
USB A to USB C adapter for smartphone use
17
Connection cable handbrake
TOOLS REQUIRED
-
Torx screwdriver T25
-
Phillips screwdriver
-
Fabric tape
Modell Typ
250 / 251
250 / 251
250 / 251
SERIE 8*
SERIE 9*
250 / 250D / 250L
250 / 251
Typ C
Typ C
Modell Jahr
2006 - 2011
2011 - 2014
as of 2014
2021 -2023
as of 2023
as of 2006
as of 2006
as of 2021
as of 2021
Qty
1
2
4
1
1
1
1
1
1
1
1
1
2
1
1
1
1