Installation Instructions; Water Connection; Power Connection - Inoksan BYM102B-HR Gebrauchsanweisung

1. INSTALLATION INSTRUCTIONS


Carry the device to the place of
installation and remove it from its
package.

Check whether the device is in a solid
state. If there is damage, immediately
notify this situation to your dealer and if
you have any doubt do not operate the
device without having it checked by an
expert.

Peel away the protective nylon on the
device. If there are material remains left
on the surface, clean them with a
convenient
Example;Henkel-Helios)

If possible, place the device near a water
connection and waste water drain.

2. WATER CONNECTION


Connect your device to the city water
normally. However, you can also connect
it to the hot water input in order to save
electricity.

Perform the connection between the
device and the tap with the provided
flexible hose.

In order for the device to work correctly,
the input water must be at 7 Fr hardness
and min 2 bar, max 4 bar pressure.
WARNING:

Drain pipe required to be connected to a
drain at height 50 mm from ground for
base model devices and at max. 700 mm
from the ground for the devices with
pump to maintain a reliable water
 For longer life and efficiency of your
device, attach a lime remover at the water
input. Otherwise the lime scale that will
accumulate at the internal surfaces of the
boiler and pump will prevent the device
from working efficiently.

3. POWER CONNECTION


The installation and power connection of
the device must be performed by
authorized personnel according to the
standards.

Usage of a H07 RN-F quality 5x4 mm
profile cable is necessary for the power
connector line.
dissolver. (For
flow.
2

The device needs to be connected to a
master switch (contact distance 3mm or
more) and to a fused isolator.

Voltage tolerance ± must not go over %
10.

A maximum of 25A fuse must be put to
the device feed line.

We recommend the usage of a 30 mA
faulty residual current device.
 The device must absolutely be grounded.
For this, DIN VDE 0100 clause 540 must
be taken into consideration. Grounding
screw is indicated at the bottom left
section with the "
4. USER INSTRUCTIONS

The machine is designed for washing;
trays, plates, glasses, cups, knives and
forks etc. dishes inside specially designed
cases for medium scale businesses and all
cafeteria type facilities where mass
catering services are provided.

The machine must always be operated by
qualified personnel, assigned for this
work.

The machine has the feature of washing
maximum 380mm height and other
objects.

Water is an important factor for getting a
good washing result. For this reason, if
the hardness of water passes 12 Fr, we
recommend using a "water softener".

For a good washing quality, soaking the
dishes before putting them inside the
machine is advised. Otherwise the food
residue, lemon peels, toothpick etc.
materials can block the materials drain
pump and alter the washing quality.

Two types of chemical products are used
in the machine. These are detergent for
washing, and polisher for polishing. The
detergent must be an industrial type
(powder or liquid) and foam free. Apply
the determined values by the detergent
manufacturer for
(Detergent amount can vary according to
the hardness of water.)

As standard accessory; there is 1 plate and
1 cutlery tray in 500x500 mm size in the
machine.
9
" tag.
the used amount.