Using The Machine - Inoksan BYM102B-HR Gebrauchsanweisung


Select the relevant tray according to the
dishes to be washed and load them
according to the capacities stated on the
chart. Do not start the machine without
entirely filling the tray in order to save
detergent and power.

Be mindful of the durableness of the
dishes that you will put inside the
Dishwashing Machine.

Never change the location of the machine
while it is operating.

Be sure that the water input valve is open
before operating the machine.

Cleaning of the internal parts of the
machine periodically is recommended.

In order to obtain healthy results in
cleaned dishes, the following ground rules
must be met.

Apply the manufacturer's remarks on the
detergent dosage according to the water
hardness.

The wash water must be renewed at least
3 times a day or when the water loses its
ability to clean due to dirty particles.
Washing performed with dirty wash water
causes bad washing results, along with
detergent, polisher and power wastage.
After the machine's power plug is inserted,
"2 ON / OFF button is pressed and" 1 READY
"until the position is expected. The machine is
ready for operation.

Do not dry cleaned dishes with a dirty
towel.

Do not place clean dishes on spongy
towels or other materials.

Use disposable materials or preferably the
basket system.

Make the constant cleaning of the shelves
that you use for storing dishes with
special detergents
available in the market.
NOTE: The choice of detergent can be a
determining factor in getting a good wash result,
protection and lifetime of the machine. Therefore
we recommend
contaminating products and not exceeding the
suggested detergent amount.

USING THE MACHINE

6.
6.0- Operating
1. READY
2. ON/OFF
3. P1 : 1. short program 100 sec
4. P2 : 2. medium program 150 sec
5. P3 : 3. long program 210 sec
6. IGD
ATTENTION : This position starts washing
detergent but turning it to the position P1,
since water is cold
10
and disinfectants
not using abrasive or