Appendix; Faqs - Bluetti B80P Bedienungsanleitung

5. Appendix

5.1 FAQs

Q1: How do I know whether my devices will work well with this product?
A: Please evaluate the total constant load of your devices. If it doesn't exceed the Max.
output power of B80P (120W), you can use this power station to run your devices.
Note: Some devices with built-in motor/compressor may start at 2-4 times the rated
power, which can easily overload the B80P.
Q2:
Can I use third-party solar panels to charge this product?
A:
Yes, you can. Make sure your solar panels have an open circuit voltage of 12V-28V
and have the MC4 connectors. Please do NOT mix different types of solar panels.
Note: Time required for one full charge depends on weather condition, the sunshine
intensity and the angle of solar panels.
Q3:
Can it charge and discharge at the same time?
A:
Yes. It supports pass-through charging. B80P comes with the premium LiFePO4
battery and proprietary Battery Management System to ensure that it can charge
and discharge at the same time.
Q4:
Why does the B80P shut down automatically?
A:
Two scenarios in which B80P shuts down itself:
If DC output is not turned on after power on, it will automatically shut down after 4
hours.
If DC output is less than 10W, it will automatically shut down after 24 hours.
Q5:
Why is the charging power often too low?
A:
B80P has a built-in intelligent BMS that automatically adjusts the charging power in
response to the battery temperature and SoC, thus protecting the battery and
extending its service life.
16
JUST POWER ON