Concept TM5010 Bedienungsanleitung Seite 29

EN
7
5
8
6
9
15
OPERATING INSTRUCTIONS
NOTICE
Always disconnect the plug out of the electrical outlet before assembling or removing accessories!
Before putting a new appliance into operation, you should wipe it thoroughly with a damp cloth and wash all removable
parts in warm water for hygienic reasons.
The appliance is intended for short-term operation. Do not use the appliance continuously for longer than the time
specified in the technical parameters table. Allow the appliance to cool down before further use.
BLENDING
The stick attachment is intended for preparing sauces, toppings, soups, mayonnaise, baby food, mixed drinks and milkshakes.
1. Put the foods in the blending bowl or any other higher kitchenware.
2. Place the appliance body on the shaft of the stick attachment and turn it to lock it (pull it make sure that the stick
attachment cannot be separated from the appliance body).
3. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
4. Hold the appliance body with one hand and the blending bowl with the other.
5. Insert the appliance into the blending bowl with foods and press the switch (2) to switch it on. Press to select the
blending speed. The power can be increased to Turbo. Blend the foods in a circular motion at the bottom of the
bowl. After you have finished blending, switch off the appliance. Unplug the power cord from the socket.
6. Turn and pull to remove the stick attachment from the appliance body and rinse it immediately under warm
running water. Make sure that water does not get into the inside of the attachment to the drive shaft area. If this
happens, allow the stick attachment to dry and drip a few drops of edible oil into the drive shaft area to ensure
better run of the stick attachment bearing.
56
1 1 1
10
12
17
16
18
TM5010 | TM5020 | TM5030
MAYONNAISE RECIPE EXAMPLE
200-250 ml of oil
1 egg (yolk and white)
1 tsp of lemon juice/vinegar
13
Salt and pepper to taste
Put all foods in a high container in the order described. Immerse the stick attachment to the bottom of the blending bowl.
Press the ON/OFF button and hold the appliance in this position until the oil creates an emulsion. Then slowly move the
appliance up and down until you reach the desired thickness of the mayonnaise.
14
19
CHOPPING (model TM5010 | TM5020 only)
The chopping bowl is suitable for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, almonds, prunes, etc.
Do not chop extremely hard foods such as nutmeg, coffee beans and grains.
Cut foods such as meat, cheese, onions, garlic, carrots and frozen foods first.
Remove stems from herbs, remove shells from nuts.
Remove bones, gristles, tendons and skin from meat.
1. Insert the chopping blade and foods into the chopping bowl and close it with a transmission lid.
2. Place the appliance body on the transmission lid and turn it to lock it.
3. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
4. Hold the appliance body with one hand and the chopping bowl with the other.
5. Press the switch (2) to switch on the appliance. You can use the Turbo button and briefly increase the motor speed
to maximum.
6. After you have finished chopping, switch off the appliance. Turn the appliance body and then pull it to remove it
from the transmission lid. Unplug the power cord from the socket.
7. Wipe the transmission lid of the chopping bowl with a damp cloth. Do not wash it under running water and do not
immerse it in water!
TM5010 | TM5020 | TM5030
EN
57