Technical Information; Cleaning; Troubleshooting Guide - K&H 30-IN-3600SL Gebrauchsanleitung

3-4
Low level
1-3
Power off 0/H
Note: The data in the table is for guidance only. The relation between the heat setting and the
cooking zone consumption of power is not linear. When you increase the heat setting it is not
proportional to the increase of the cooking zone consumption of power.
The power of the cooking zones can be different in some small range. It changes with the material and
dimensions of the cookware.

TECHNICAL INFORMATION

Voltage: 220 - 240 V 50/60 Hz
Max. power: 3400W

CLEANING

Ÿ Do not use steam cleaners.
Ÿ Before cleaning, make sure the cooking zones are switched off and that the residual heat
indicator ("H") is not displayed.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
Ÿ After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
Ÿ Sugar or foods with a high sugar content damage the hob and must be immediately removed.
Ÿ Salt, sugar and sand could scratch the glass surface.
Ÿ Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer's
instructions).

TROUBLESHOOTING GUIDE

Ÿ Read and follow the instructions given in the section "Instructions for use".
Ÿ Check that the electricity supply has not been shut off.
Ÿ Dry the hob thoroughly after cleaning it.
Ÿ If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table
for instructions.
Ÿ If the hob cannot be switched off after using it, disconnect it from the power supply.
Error
code
E0 No Pan or did not detect the pan
E2
E3 High voltage
E4 Low voltage
Ideal for softening butter, gently melting chocolate, thawing small
Melting – products and keeping just-cooked
defrosting – food warm (e.g. sauces, soups, minestrone)
keeping – food
Ideal for keeping just-cooked food warm, for creaming risottos and
warm - creaming
for keeping serving dishes warm
(with induction-suitable accessory)
Support surface Hob in stand-by or off mode (possible end-of-cooking residual
heat, indicated by an "H")
Possible Cause
NTC short or open
Put on the pan
Contact the after-sales service and specify the
error code
Contact the after-sales service and specify the
error code
Contact the after-sales service and specify the
error code
18
Remedy