Herunterladen Inhalt Inhalt Diese Seite drucken

Control Panel Layout - K&H 30-IN-3600SL Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CONTROL PANEL LAYOUT

Switching the hob On/Off
To switch the hob on, press the
press the same button until the displays switch off. All the cooking zones are deactivated
If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled
down.
If within 120 seconds of switching on, no heating zone is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Once the hob is switched on and the pan is positioned on the chosen cooking zone, select the
zone using the corresponding button: the display shows level 0.
Each cooking zone has various power levels, adjustable with the
P – POWER LEVEL/BOOSTER
The button
minutes, this function returns to level 16. The booster function only works on one cooking zone!
Deactivation of cooking zones
Select the cooking zone you wish to switch off. Press the corresponding button.
Press the key "0" to set the level to "0". The cooking zone switches off and the residual heat indicator "H"
lights up.
Child lock
This function locks the controls to prevent accidental switching on of the hob. To activate the
child lock function, switch on the hob and hold button
Then the control panel is locked.
To deactivate the control panel lock, repeat the activation procedure. The Lo goes off and the hob is active
again.
Timer
The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes)
for all cooking zones.
Select the cooking zone to be used with the timer, press the button with the clock symbol
then set the desired cooking time using the
seconds, the timer begins the countdown. Once the set time has elapsed, an acoustic signal sounds and the
hob switches off automatically.
To cancel the timer, press and hold the timer button for two seconds.
button and the cooking zone displays light up. To switch off,
buttons, going from "1": min. level, to "16/P": max. level.
is used to select the power level. After 5
/
buttons of the timer function (see figure). After a few
16
for three seconds; the timer shows Lo.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis