Gude DHH 1050/7 TCW Betriebsanleitung Seite 16

Electrical/hydraulic connection
Connection
Based on provisions of field professional organisations "CE", all splitters have been fitted with an undervoltage release in the switch.
This prevents appliance self-starting in case supply is interrupted as a result of power failure, unintentional unplugging, defective fuse,
etc. The appliance must necessarily be switched on by pressing the green switch button.
Intentional holding or blocking the switch button with a neutral conductor missing leads to automatic switch outage. In such a case that
may subsequently be identified, the warranty will not apply.
Only for 400 V appliances:
The engine rotation direction (see the arrow on the appliance) must be respected as
running with wrong rotation direction may damage the oil pump. In such a case, all
claims arising from the warranty will not apply. If necessary, have the rotation
direction changed by reversing the plug polarity by a professional electrician. See
the picture! (three-phase models only!)
Hydraulic equipment
Tightness must be checked at hydraulic hoses and couplings after app. 4 hours of
operation and tightening provided if necessary.
Hydraulic oil/tank
Common hydraulic oil (e.g. BHLP 46 or oil with the same viscosity of another manufacturer) may be
added to all splitters. Oil change not necessary.
Transport instructions
Transport
All log splitters have been fitted with big wheels. To transport the splitter, grab the splitter post handle with one hand and the handle
above the engine by the other hand and tilt slightly the splitter to you. In this position, the splitter may easily be moved.
To prevent hydraulic oil leak, the splitter must never be moved when laying.
Lower the splitting knife down to full extent when moving the appliance.
Guarantee
The guarantee solely covers inadequacies caused by material defect or manufacturing defect.
Original payment voucher with the sales date needs to be submitted for any claim in the guarantee period.
The guarantee does not cover any unauthorised use such as appliance overloading, use of violence, damage as a result of any
unauthorised interference or caused by foreign items. Failing to follow the operating and assembly instructions and common wear are
also not included in the guarantee.
Failures
Failure
No splitter power
After being pressed, the green switch
button not remaining pressed
Hydraulic pump whistling; splitting knife
jerky
No works other than works for which the appliance has been designed and that are specified in these Operating Instructions
Cause
-
Wrong rotation direction (400 V only)
-
Too little of hydraulic oil
-
Switching rod is bent; hydraulic lifter
not pressed to full extent
-
Neutral not connected
-
Defective fuse, etc. (400 V only)
-
2-phase running (400 V)
-
Too little of hydraulic oil
may be performed with this appliance.
16
Remedy
-
Have the rotation direction changed by
a professional
-
Add hydraulic oil
-
Adjust the rod mechanism; tighten the
appropriate nuts.
-
Have the cable or network checked by
a professional
-
Check the cable
-
Add hydraulic oil