White Bal; Focus Mode; Motion Det - Samsung SCC-C4205 Gebrauchsanleitung

❙

WHITE BAL

You can select one of four modes for white balance adjustment as
follows:
- ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes,
the color temperature is monitored continuously and thereby white
balance is set automatically. The following are the approximate
supported color temperature ranges in these modes.
ATW1 : 2500K ~ 9300K(✻1)
ATW2 : 2000K ~ 10000K(Mode recommended for sodium
lighting)(✻2)
✻ 1. If the color temperature is out of this range in ATW1 mode,
proper white balance may not be obtained. In that case, select
ATW2 mode.
✻ 2. In ATW2 mode, if one color is dominated in the shooted area,
the color can be displayed differently. Therefore, select the
mode which is appropriate for the environment.
- AWC(Auto-Tracing White Balance Control): In this mode, accurate
white balance is obtained by pressing [ENTER] while having a
white paper in front of the camera. White Balance data will be
maintained after set it once. AWC mode is best in locations where
the color temperature of light source is constant.
- MANU : If WHITE BAL menu is set to MANU mode, the user can
set the white Balance considering the current illumination. Select
MANU item and press [ENTER], the sub screen where you can
select Manual White Balance will be shown. Use the left/right keys
to select 3200K, 5600K or OFF(USER) mode in the PRESET
menu.
✔
3200K : Set color temperature to 3200K
✔
5600K : Set color temperature to 5600K
✔
USER : Choose out a proper value from the RED and BLUE
graph for color and temperature setup.
(MANU)
PRESET
RED
BLUE
RET
21
All manuals and user guides at all-guides.com
OFF(USER)..
(80) - - - - I - - - -
(80) - - - - I - - - -
❙

FOCUS MODE

The FOCUS MODE menu performs AF(Auto Focus),
MF(Manual Focus), and ONEAF(One Auto Focus).
✔
AF : Focuses automatically by continuously monitoring the
screen in AUTO FOCUS mode. It does not process the
FOCUS button input because it focuses automatically
during ZOOM.
✔
MF : You can manually adjust the focus.
✔
ONEAF : Focuses about 5 seconds only when ZOOM is
moved Wide to Tele. It is same as MF mode while
in STOP
mode, and same as AF mode after ZOOM Tele.
CAMERA ID
IRIS
SHUTTER
AGC
WHITE BAL
FOCUS MODE

MOTION DET

COLOR/BW
PRIVACY
SPECIAL
PRESET
EXIT
❙
MOTION DET
MOTION DET detects any motion. Set up this function
during no human movement to detect break-in. Once
detected, an ALARM signal will be given for 5 seconds. As
MOTION DET detects any motion, so it can set up the
motion detection sensitivity. Select ON... and press [ENTER]
and the MOTION DET submenu screen will appear.
OFF
ALC...
OFF
LOW
ATW1
AF
OFF
COLOR
OFF
...
...
QUIT
22
E