Technical Data - Bosch Kiox 300 Originalbetriebsanleitung

English – 2

Technical data

On-board computer
Product code
Operating temperat-
A)
ure
Storage temperature
Protection rating
Weight, approx.
A) Temperatures outside of this range may cause faults in the dis-
play.
The licence information for the product can be accessed at the follow-
ing Internet address: www.bosch-ebike.com/licences
Assembly
Inserting and Removing the On-Board Computer
(see figure A)
To fit the on-board computer (1), attach it to the front edge
of the display mount (5) in the direction of travel, on the
snap-in hook (6) on ❶ and press the rear side of the on-
board computer (1) onto the display mount (5) ❷.
To remove the on-board computer (1), pull it towards you ❶
until you are able to lift off the on-board computer (1) ❷.
A retaining strap can be secured to the bridge (9).
Note: The eBike switches off if you ride below 3 km/h and
take the on-board computer out of the holder. This does not
apply to eBikes with assistance up to 45 km/h.
Inserting the Removal Blocker (see figure B)
Note: Depending on the design/mounting of the display
mount, it may not be possible to insert the removal blocker.
The on-board computer must be mounted.
Insert the removal blocker (4) into the adapter tray (10)
from below until you hear the removal blocker (4) click into
place.
From this point onwards, you can no longer remove the on-
board computer (1) from the display mount (5) without re-
moving the display mount (5) from the adapter tray (10) by
loosening the two fastening screws (11).
Note: The removal blocker (4) is not an anti-theft device.
Operation
The on-board computer can be operated using one of the op-
erating units shown. The functions of the buttons on the op-
erating units can be found in the following overview.
Depending on how long it is pressed for, the select button
has 2 functions.
0 275 007 3BK | (14.02.2023)
Kiox 300 Kiox 500
BHU3600 BHU3700
°C –5 to +40 –5 to +40
°C +10 to +40 +10 to +40
IP55
g 32
Three-button operating unit
IP55
61
Increase assistance level
Decrease assistance level
Select button (press briefly)
Scroll through the screens (press briefly)
Select button (press and hold > 1 s)
Open settings menu (press and hold > 1 s)
Five-button operating unit
Scroll to the left
Scroll to the right
Scroll up
Scroll down
Select button (press briefly)
Open the settings menu on the status page (press
briefly)
Open the quick menu (from any page except for the
status page) (press for > 1 s)
Note: The fault codes can be acknowledged using the but-
ton on the operating units shown.
Note: All screenshots showing the display and text on the
following pages are from the approved software version. The
display and/or text may change following a software update.
Status page
From the start screen, you can access the status page via the
button on the five-button operating unit and via the
button on the three-button operating unit.
Bosch eBike Systems