Ecotech Italia H24 LYNX Bedienungsanleitung Seite 120

11. The warning light L starts to flash at a slow fre-
quency.
The indicators show that the remote control is con-
EN
nected to the machine.
12. Press and hold command N and release it when
the engine switches on.
– The warning light C goes off.
– Operate command P to regulate the maximum
movement speed of the machine.
13. Operate command Q to reach the maximum
number of engine revolutions.
14. Operate the joystick commands R-S to move
the machine close to the working area.
15. Operate command T to bring the cutting deck to
the required height.
16. Turn command F to "ON".
– The cutting blades are activated.
– The engine revolutions increase up to the maxi-
mum.
17. Operate the joystick commands R-S to perform
the work.
120