Cleaning And Maintenance; Environmental Information - Power Craft 89488 Gebrauchsanweisung

Clean the shaft and flanges, fit a new blade and
replace the outer flange and nut. Check that the
orientation of the blade matches the rotation
direction of the motor.
Replace the table inlay and blade guard.
Adjust the cleaver blade.

Cleaning and maintenance

Remove any sawdust and dirt using a vacuum
cleaner, compressed air or a brush. Check that the
motor ventilation slots are not blocked.
The saw can be cleaned by wiping its exterior parts
with a damp cloth.
Remove the base plate and lubricate all moving
parts with a light oil.
Never use strong or corrosive detergents on the
blade. These can damage the light metal parts of
the saw and affect its function.
If the carbon brushes are worn, they should be
replaced.
ENGLISH
USER MANUAL

Environmental information

HP Værktøj A/S endeavours to manufacture
environmentally friendly electrical and electronic
products; we also wish to contribute to the safe
disposal of waste substances which may be
environmentally hazardous.
A healthy environment is important for everyone,
and we have therefore set ourselves the target of
complying with the requirements in the EU's
initiatives in this area, which means we guarantee
the environmentally sound collection, treatment,
recovery and disposal of electronic equipment
which might otherwise harm the environment.
This also means that our products do not contain
any of the following chemicals and substances:
- Lead
- Mercury
- Cadmium
- Hexavalent chrome
- PBB (polybrominated biphenyls) (flame
retardants)
- PBB (polybrominated diphenyl ethers) (flame
retardants)
HP Værktøj A/S is proud to support the EU's
environmental initiatives in order to play a part in
a cleaner environment and hereby declares that
our products comply with both the WEEE
Directive (2002/96/EC) and the RoHS Directive
(2002/95/EC).
As a consumer, you can also play a part in
protecting the environment by following the
applicable environmental regulations and taking
old electrical and electronic equipment to your
local recycling center. If the equipment contains
batteries, you must remember to remove these
before you dispose of the equipment.
37