Oase BioTec ScreenMatic2 40000 Gebrauchsanleitung Seite 58

Aligning the control device
Do not align the control device until after the running-in period
 Lowering the pump into the pond may swirl up so much debris that starting up the filter sys-
tem straight away could cause the ScreenMatic screen to overflow.
 The filter system requires a running-in period of 2 to 3 hours. After this, the control device can
be aligned if necessary.
 Align the control device such that the sensor only switches when a well-formed line of debris
has formed on the screen.
– A well-formed line of debris can be optimally removed by the stripper and conveyed into the
debris tray.
– The stripper brush under the ScreenMatic screen collects the fine debris, which falls into the
debris tray.
How to proceed:
1. Remove the screw from the control device and take out the control device.
2. Insert the control device into the determined position, insert the screw and hand tighten.
Aligning the control device depending on the degree of soiling of the pond
In order to prevent premature soiling of the foam filters, ensure that the dirty water does not
flow beyond the "Max. water jet" mark directly into the debris tray.
 Do not change the position of the control device unless the water flows as far as or beyond
the "Max. water jet" mark, even when the ScreenMatic screen has been cleaned (with the en-
closed brush). (→ Cleaning/replacing the ScreenMatic screen)
58