Oase BioTec ScreenMatic2 40000 Gebrauchsanleitung Seite 54

Connecting a UVC clarifier
Fitting the outlet
Prerequisite:
 The container is open. (→ Remove the container cover)
 The screen holder is hinged up. (→ Hinging the screen holder up/down)
How to proceed:
1. Fit the UVC clarifier with flat seal into the inlet opening.
2. Screw the distributor nut with O ring onto the stepped hose adapter and hand tighten.
– Read the UVC clarifier operating instructions.
Outlets
 Use suitable pipes.
 Do not use any right-angled bends. Bends with a maximum angle of 45° are very efficient.
 Standing water in pipes can freeze when there is a hard frost and cause pipes to burst. For this
reason, lay the pipes and hoses with a gradient (50 mm/m) to ensure that they can run empty.
 Pipe dimensions: (→ Unit data)

Support the connected pipes. This increases the stability of pipe constructions and pre-
vents them from sagging.
54
BTC0059