Motor Start/Stop; Motor Stop - Modster EC-135 Betriebsanleitung

Manual
During gyroscope calibration, it is important to place the aircraft on a level surface to
ensure accurate flight� The gyroscope is already calibrated at the factory, so users do
not need to calibrate it again unless they are unable to exit the initialization or if there
is yaw drift in manual attitude mode� In such cases, recalibration is necessary�
After successful calibration, the indicator light will provide prompts based on the cur-
rent position of the remote control's switch, as explained in the indicator light section�

Motor Start/Stop

Motor Start: Perform the throttle stick action to start the motor� Immediately release the
stick after starting the motor� Push the throttle stick upward by more than 50%, and the
aircraft will take off�

Motor Stop

There are two methods to stop the motor after it has started:
Method 1: After the aircraft has landed, move the throttle stick to the lowest position
and hold it for at least 3 seconds to stop the motor�
Method 2: After the aircraft has landed, pull both joysticks inward simultaneously to
stop the motor immediately� Release the sticks after the motor has stopped�
1
32
2
MODSTER EC-135
www.modster.at