PLASTIC MOUNTING INSTALLATION
1. Fasten the plastic pole onto your fix pole with mounting base, clamp, washers, screws and
nuts. Following below 1a, 1b, 1c sequences:
1a. Insert the plastic pole into the hole of the mounting
stand, and then secure it with the screw and nut.
1b. Apply 2 rubber pads on the mounting clamp.
2. Apply 4 rubber pads on the inner sides of the mounting base
and clamp of the 7-in-1 sensor, and loosely fasten them
together.
Note:
Plastic pole placed under
the egg tray, please check
before disposal of the
packaging.
1c. Fasten the mounting stand and
clamp together onto a fix pole with
4 long screws and nuts.
8