Accessories - Sharp SJ-BE237M01X-EU Bedienungsanleitung

CHAPTER -3: USING YOUR FRIDGE FREEZER

Accessories

Ice tray
• Fill the ice tray with water and place in freezer compartment.
• After the water completely turned into ice, you can twist the tray as shown below to get the ice cube.
Adapti-Lift Door Shelf (In some models)
Fig.1
Note: Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Bottle holder (In some models)
In order to prevent the bottles to slip or fall over you can use the bottle holder. You can also prevent making noise that
will be done when you open or close the door.
Humidity Controller (In some models)
When the humidity controller is in the closed position, it allows
fresh fruit and vegetables to be stored for a longer time.
In the event the crisper is full, the fresh dial that is located in
front of the crisper, should be opened. By means of this, the
air in the crisper and humidity rate will be controlled and the
shelf life will be extended.
If you see any condensation on the glass shelf, the humidity
control should be placed into the open positions.
Visual and text descriptions on the accessories section may vary according which model you have..
Cleaning
• Before cleaning your fridge freezer, turn your mains supply off and remove the plug from the socket.
• Do not wash your fridge freezer by pouring water on to it.
• Use a warm, soapy cloth or sponge to wipe the interior and exterior of your fridge freezer.
• Carefully remove all shelves and drawers by sliding upwards or outwards and clean with soapy water. Do not
wash in a washing machine or dishwasher.
• Do not use solvents, abrasive cleaners, glass cleaners or all purpose cleaning agents to clean your fridge
freezer. This may cause damage to the plastic surfaces and other components with the chemicals they contain.
• Clean the condenser at the back of your fridge freezer at least once a year with a soft brush or vacuum cleaner.
Make sure that your fridge is unplugged while cleaning.
Replacing LED Lighting
If your fridge freezer has LED lighting contact the Sharp help desk as this should be changed by authorized personnel
only.
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
EN -8-
Fig.2