Accessories - Sharp SJ-BA20IEXAC-EU Bedienungsanleitung

CHAPTER -3: USING YOUR FRIDGE FREEZER

Accessories

Freezer box
• The freezer box is for foods that need to be accessed more easily.
• Removing The freezer box;
• Pull the box out as far as possible
• Pull the front of box up and out.
! Make the inverse of the same operation for the resetting the sliding
compartment.
Note: Always hold the handle of box while moving in or out.
Zero Degree Zone (In some models)
Keeping food in the chill drawer instead of the freezer or refrigerator compartment
allows food retain freshness and flavour longer while preserving its fresh appearance.
If the chiller tray becomes dirty, remove it and wash with water.
(Water freezes at 0 °C, but foods containing salt or sugar require lowered
temperatures to freeze)
Normally people use the chill drawer for raw fish, rice, etc...
Do not put foods you want to freeze or ice trays in order to make ice.
Removing the chill drawer
Pull the chiller shelf out toward you by sliding it on rails.
• Pull the chiller shelf up from the rail to remove.
After the chill drawer has been removed, it can support a maximum 20 kg load.
Humidity Controller
When the humidity controller is in the closed position, it allows fresh fruit and
vegetables to be stored for a longer time.
In the event the crisper is full, the fresh dial that is located in front of the crisper,
should be opened. By means of this, the air in the crisper and humidity rate will be
controlled and the shelf life will be extended.
If you see any condensation on the glass shelf, the humidity control should be
placed into the open positions.
Adapti-Lift Door Shelf (In some models)
Fig.1
Note: Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
Freezer boxes
EN -12-
Fig.2