LOOPER THREAD CONTROL
1. Set the the looper thread take-up lever to just
contact the thread when the needle enters the throat plate.
2. The amount of strike off should be set so the
thread just becomes tight as the looper reaches its
furthest end of the travel.
GREIFERFADENKONTROLLE
1. Stellen Sie den Greiferfadenabzugshebel so ein, dass
er gerade den Faden berührt, wenn die
Nadelspitze sich an der Oberkante der Stichplatte befindet.
2. Die Menge des abgestreiften Fadens so eingestellt
werden, dass dieser gespanntist, wenn der Greifer
seine linke Endstellung erreicht hat.
22