Replacing The Lamp; Closing The Door - Leonard LK0813 Benutzerinformation

Problem
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
2
Possible cause
There is no cold air circula‐
tion in the appliance.
1
1
Solution
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
2. Replace the bulb with one of the same
power and shape, specifically
designed for household appliances.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Leonard 13