Replacing The Lamp; Closing The Door - Leonard LK1204 Benutzerinformation

24 Leonard
Problem
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. With your fingers, spread slightly both
sides of the transparent cover to
unhook them and detach the cover
pulling it in the direction of the arrows.
2
Possible cause
The appliance is fully loaded
and is set to the lowest tem‐
perature.
You attempted to re-open
the door immediately after
closing.
1
1
Solution
Set the temperature regula‐
tor to a higher temperature
to allow automatic defrost‐
ing.
Wait a few seconds between
closing and re-opening of
the door.
2. Replace the lamp with the one that has
identical characteristics and is
specifically designed for household
appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.