Replacing The Lamp - Leonard LK0843 Benutzerinformation

26 Leonard
Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
There is frost on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Possible cause
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
The ambient temperature is
high and the appliance is set
to the lowest temperature
The appliance is fully loaded
and is set to the lowest tem‐
perature.
You attempted to re-open
the door immediately after
closing.
1. With your fingers, spread slightly both
sides of the transparent cover to
unhook them and detach the cover
pulling it in the direction of the arrows.
Solution
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Set the temperature regula‐
tor to a higher temperature
to allow automatic defrost‐
ing.
Set the temperature regula‐
tor to a higher temperature
to allow automatic defrost‐
ing.
Wait a few seconds between
closing and re-opening of
the door.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.