Replacing The Lamp; Closing The Door - Leonard LKT1441 Benutzerinformation

26 Leonard
Problem
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. Using a screwdriver, remove the screw
from the lamp cover.
2. Detach the lamp cover in the direction
of the arrows.
Possible cause
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
3. Replace the lamp with the one that has
identical characteristics and is
specifically designed for household
appliances.
4. Reassemble the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light switches on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessa‐
ry.
Make sure that there is cold
air circulation in the appliance.