HOP-SPORT HS-1500L B Bedienungsanleitung Seite 72

GB Cleaning and maintenance
WARNING! Always unplug the treadmill from the socket before the cleaning or repair.
Cleaning
• Keeping the treadmill clean will extend its lifetime.
• Take care of the cleanliness of the device by removing dust regularly.
• Clean both sides of the treadmill belt and also side rails.
• To clean the device, use soft cloth, slightly wetted with water. Do not use any strong detergents or sharp cleaning cloths, which can damage
the device.
• After each use of the device, remove any sweat and dirt marks.
• Always wear clean running shoes on treadmill, it will lower the amount of dirt under the treadmill belt.
WARNING! Always unplug the treadmill form the socket before you remove the engine lid. At least once a year take of the engine lid and vacuum
the space under the lid.
Treadmill belt and plate lubrication
1. This model of treadmill is factory lubed. Friction of belt and plate may be essential
to the treadmill lifetime and efficiency. That's why it needs to be periodically lubed.
2. It is recommended to check the plate periodically. If you notice the damage
to plate, contact the service.
3. Frequency of lubrication depends on the exploitation conditions.
4. It is recommended to lubricate the plate in accordance to the schedule below:
• low intensity of exploitation (less than 3 hours a week) – once a year,
• medium intensity of exploitation (3-5 hours a week) – every six months,
• very intense exploitation (over 5 hours a week) – every three months.
5. It is recommended to use non-fat lubricant.
Warning! Each treadmill belt repair has to be done in a professional service.
Treadmill belt centering
1. It is recommended to unplug the treadmill from the power source for 10 minutes after each 2 hours of continuous training.
2. Loose treadmill belt will move with difficulty during running and may cause slipping or falling of the user during exercising. Too much
stretched (tense) treadmill belt may cause a decrease in engine efficiency and create bigger friction between roll and belt.
3. Set the treadmill on the horizontal ground. Start the treadmill with speed of 6-8 km/h. Use hex key 5 mm (58).
• If the treadmill belt moves towards right, take out the right rear plug, twist the adjustment screw on the right side clockwise by 1/4 of spin,
then start to run until the belt is centered (Pic. A).
• If the treadmill belt moves towards left, take out the left rear plug, twist the adjustment screw on the left side clockwise by 1/4 of spin, then
start to run until the belt is centered (Pic. B).
• If the belt still isn't in the middle, repeat above actions until the belt is centered.
• Once in a while regulate the tension of the belt to prevent it from loosening caused by exercising. Take out the rear plugs, twist the left
and right adjustment screws by 1/4 spin clockwise then start the treadmill. Check the belt tension until it is stretched correctly (Pic. C).
Open the plug
of oil container
68
Put the bottle to
the oil container slot