Cleaning, Maintenance And Ordering Spare Parts; Transport - EINHELL PICOBELLA 18/215 Originalbetriebsanleitung

7. Cleaning, maintenance and
ordering spare parts
Before putting away or cleaning the equipment,
switch off and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment im-
mediately each time after use.
•
Clean the equipment regularly with a damp
cloth. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts
in the equipment. Ensure that no water can
get into the interior of the equipment. The
ingress of water into an electric power tool
increases the risk of an electric shock.
•
Remove the safety guard and remove any
deposits using a brush.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
MEDIUM replacement brush (nylon, black)
Art. No. 34.241.20
SOFT replacement brush (nylon, yellow/green)
Art. No. 34.241.21
ULTRA replacement brush (metal)
Art. No. 34.241.22
ULTRA SIDE replacement brush (metal)
Art. No. 34.241.26
Anl_Picobella_18_215_SPK13.indb 26 Anl_Picobella_18_215_SPK13.indb 26
GB
8. Storage
Store the equipment and its accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric equipment in its original
packaging.
Do not bend the rubber lips of the splash guard
(Fig. 19 / Item 14) outwards. Store the equipment
in such a way that the rubber lips are not in con-
tact with the fl oor/ground as far as possible.

9. Transport

•
Always hold the equipment with one hand on
the handle and the other hand on the additio-
nal handle. Do not carry the equipment by its
motor housing.
•
Secure the equipment against slipping if you
transport it in a vehicle.
•
As far as possible, use the original packaging
for transporting the equipment.
10. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
- 26 -
10.05.2023 08:51:42 10.05.2023 08:51:42