Charging The Battery Pack Mounted On The Bicycle - Batavus Yamaha 2014 Bedienungsanleitung

If a charging fault occurs during charging, remove the power plug of the battery charger
WARNING
from the socket and wait for the battery pack/battery charger to cool.
TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is charging, all normal displays will be shown,
including the battery capacity indicator, but the assist system will not function.
• When the battery pack is connected to the battery charger, battery charger lamp will flash at
approximately 0.2 second intervals to indicate that charging is preparing to charge the battery pack.
Leave it as it is and charging will start normally.
• Charging stops automatically once the battery is fully charged. You do not have to disconnect the
charger immediately. You can simply leave the charger connected to the battery all day or night.
58

7.3 Charging the battery pack mounted on the bicycle

1. Connect the power plug of the battery charger to a household
power outlet.
2. Remove the lid of the battery holder cover and the cap of
charging inlet from the charging connector on the battery pack,
and connect it to the charging plug on the battery charger.
NOTICE
Do not connect the charging plug on the battery charger to a wet
charging connector on the battery pack as this can cause the
battery pack to break down. Be sure to connect the charging plug
only after the charging connector on the battery pack is completely
dry. Do not apply excessive force to the charging plug or pull on the
cord with the charging plug connected to the battery. Otherwise,
the plug or connector may be damaged.
3. See point 7.5 on page 24, and check that the battery charger is
charging the battery pack.
4. The battery capacity indicator lamps will light up one by one
until all four are on. Then, when charging is complete, all of
the lamps will go off.
5. Confirm that charging is complete, and then disconnect the
charging plug from the battery pack. How to disconnect the
plug (see the left figure):
1: Grasp the lock-release ring.
2: Pull it out straight.
6. Place the cap of charging inlet on the battery pack's charging
connector.
7. Close the lid.
Never handle the power plug or charging plug or
WARNING touch the charger contacts with wet hands. This
could result in electric shock.