Pushing Assist; Clock And Km/Mile Settings - Batavus Yamaha 2014 Bedienungsanleitung

54

6.20 Pushing assist

When you are on or off the bicycle and start moving it, you can use
pushing assist without pedaling the bicycle.
To use pushing assist, press and hold the pushing assist switch.
Pushing assist will stop in the following situations:
• When you release the pushing assist switch.
• If you press another switch at the same time.
• When you start to pedal.
• If your bicycle speed exceeds 6 km/h.
• If you select Off mode.
• I f the wheels are not turning (when braking or coming into
contact with an obstacle, etc.).

6.21 Clock and km/mile settings

Use the following steps to set the time and km/mile settings:
1. Make sure that the display is mounted on the display holder,
and that the display unit is turned off.
2. Press the power switch while holding the function select switch.
3. When the "hour" on the clock begins to flash, release the
switches.
4. Use the assist mode switches (up & down) to set the "hour".
5. Press the function select switch, and the "minutes" on the clock
will begin to flash.
6. Use the assist mode switches (up & down) to set the "minute".