Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Original Instruction Manual
Figure 4
Changing the cutting wheel
Fig 5
Fig 6
1. Unplug the machine from the power source!
2. Remove the water tray from underneath the tile saw.
3. Remove the blade cover by removing the screws on each side of the blade
cover (Figure 5).
4. Use a 19mm and an 8mm open-end wrench to loosen and remove the
arbor nut from the motor spindle as shown in Figure 6.
5. Slide the outer flange (Figure 6) and the saw blade off the end of the motor
spindle.
6. Slide the new blade and the outer flange over the end of the motor spindle.
Note–Make sure the directional arrow printed on the saw blade is pointing in a
counter-clockwise direction when viewing the saw facing the arbor nut.
7. Thread and tighten the arbor nut onto the motor spindle to secure the saw
blade.
8. Re-install the blade cover.
MAINTENANCE
Keep the ventilation openings clear and clean the product regularly.
If something unusual occurs during use, switch off the supply and disconnect
the plug. Inspect and repair the tool before using it again.
13
Werbung
Inhaltsverzeichnis
