Vibration And Noise Reduction - HBM Machines 10785 Original Bedienungsanleitung

4. The mounting of superabrasives shall be carried out according to the
instructions provided by both, the superabrasive and the machine
manufacturer. Special attention shall be drawn to the fact that mounting of
superabrasives is to be carried out by a qualified trained person. Each time
after mounting, the superabrasive shall be test run for a reasonable time –
the specified maximum operating speed of the superabrasive shall not be
exceeded.
5. The following instructions shall be observed, supplementary to the
information of the cutting machine:
– Observance of the user's information of cutting machine manufacturer.
– Before starting, safety devices shall be mounted to the machine.
– No cutting operations without protection by safety devices.
– Use of personal protective equipment according to the type of machine
and type of application, e.g. eye and face protection, ear protection,
respiratory protective devices, protective footwear, protective gloves
and other protective clothing.
– Only cutting operations for which the superabrasive is suitable shall be
carried out (taking into account restrictions of use, safety indications or
other information).

VIBRATION AND NOISE REDUCTION

To reduce the impact of noise and vibration emission, limit the time of
operation, use low-vibration and low-noise operating modes as well as
wear personal protective equipment.
Take the following points into account to minimize the vibration and noise
exposure risks:
1. Only use the product as intended by its design and these instructions.
2. Ensure that the product is in good condition and well maintained.
3. Use correct cutting attachments for the product and ensure they are in
good condition.
4. Keep tight grip on the handles/grip surface.
5. Maintain this product in accordance with these instructions.
6. Plan your work schedule to spread any high vibration tool use across a
longer period of time.
Wear hearing protection !
WARNING!
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another the
declared vibration total value may also be used in a preliminary assessment of
exposure
Depending on the actual use of the product the vibration values can differ from
the declared total. Adopt proper measures to protect yourself against vibration
exposures. Take the whole work process including times the product is running
under no load or switched off into consideration.
Original Instruction Manual
8