Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16. Remove adjusting keys and wrenches
- From habit of checking to see that keys and adjusting wrenches are
removed from the tool before turning it on.
17. Avoid unintentional starting
- Ensure switch is in "off" position when plugging in.
18. Use outdoor extension leads
- When the tool is used outdoors, use only extension cords intended for
outdoor use and so marked.
19. Stay alert
- Watch what you are doing, use common sense and do not operate the
tool when you are tired.
20. Check damaged parts
- Before further use of tool, it should be carefully checked to determine
that it will operate properly and perform its intended function.
- Check for alignment of moving parts, binding of moving parts, breakage
of parts, mounting and any other conditions that may affect its
operation.
- A guard or other part that is damaged should be properly repaired or
replaced by an authorized service centre unless otherwise indicated in
this instruction manual.
- Have defective switches replaced by an authorized service centre.
- Don't use tool if switch does not turn it on and off.
21. Warning
- The use of any accessory or attachment other than one recommended
in this instruction manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person
This electric tool complies with the relevant safety rules. Repairs should
-
only be carried out by qualified persons using original spare parts,
otherwise this may result in considerable danger to the user.
SAFETY INSTRUCTIONS SPECIFICALLY FOR TILE CUTTER
1. Do not use the product to cut other materials than those specified (e.g.
wood or metal).
2. Any modification which could lead to a change in the original characteristics
of the product (e.g. rotational speed or maximum diameter of the cutting
discs) may be carried out only by the manufacturer of the product who shall
confirm that the product is still in conformity with the safety regulations.
3. Never use cutting discs with a maximum operating disc speed less than the
rated spindle speed of the product.
4. Switch the product off and remove the plug from the power supply to
disconnect it completely.
Original Instruction Manual
6
Werbung
Inhaltsverzeichnis
