Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Line up the cut line on the tile with the saw blade.
4. Adjust the parallel fence against the edge of the tile and lock the parallel
fence into position.
5. Turn the saw ON and allow it to reach full speed. Be sure the blade runs
smoothly. The blade should also be wet from the water tray below the saw.
6. Keeping your fingers out of the cutting path, slowly slide the tile into the
moving blade.
Note—DO NOT feed the tile into the blade too fast. If the motor sounds like it is
slowing down during the cut, you are feeding the tile too fast. Slow down the
feed rate immediately.
45° Miter Cutting
Diagonal cuts can be made on rectangular tiles using the supplied angle guide.
Figure 3 shows a typical set up for cutting the corner off of a square tile.
Bevel Cutting
The saw table can be tilted up to 45° to accommodate bevel cutting. Loosen
the knob on the front of the saw to adjust the saw table as shown in Figure 4.
Use the scale on the front of the saw to set the desired table tilt angle.
Retighten the knob to secure the table.
Original Instruction Manual
Figure 2
Figure 3
12
Werbung
Inhaltsverzeichnis
