Transport - Zipper Maschinen ZI-HS12TN Betriebsanleitung

15

TRANSPORT

For easier transport, the log splitter has two wheels, a support wheel and a transport handle.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS10TN / ZI-HS12TN / ZI-HS14TN
W A R N I N G
 If a crane is used, tie the rope at the lifting point
belwo the blue bundling label, then hoist the
machine with the crane see illustration on the left.
 Never attach the crane hook to the transport
handle (a)!
 Before moving the log splitter, make sure that the
cover on the oil tank is firmly closed!
 To move the splitter, grasp the handle (a) and
carefully tilt machine backwards!
A. Moving support wheel to the transport
position:
remove the spring bolt and push the square
tube with the support wheel into the holder
(1). Then select the upper hole for transport
and fix the square tube in that position using
the spring bolt (2).
The upper hole is for transport and the
lower hole is for storage only.
B. Fold out
transport handle is normally fixed in an upright
position. To transport the log splitter, the
transport handle must be folded out as shown
in the illustration on the left. To unfold, release
the pin (1), unfold the transport handle (2)
and fix it in the unfolded position using the pin
(3).
TRANSPORT
To mount the support
C A U T I O N
the transport handle:
wheel,
The
30