Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not touch rotating parts.
The tool may be used only in two-hand operation or with the drill rig.
Keep the handles dry, clean and free of oil and grease.
Persons under 16 years of age are not allowed to use the machine.
Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing and gloves away from moving parts. Loose clothes, jewellery
or long hair can be caught in moving parts.
During use, the user must wear goggles, ear protectors and protective
boots.
Remove drill cuttings only with a hook or a brush.
During use, hold the machine with both hands and maintain a safe
standing position. Always consider the reaction moment of the
tool.
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
For further safety instructions, please refer to the enclosure.
Before starting the machine, please check the correspondence between
voltage and frequency against the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The Hand-Held Drilling Machine is made in protection class II. Only use
extension cables with a sufficient cross section. A cross section which is too
small could cause a considerable drop in performance and an overheating
of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Additional Handle
When using the machine handheld than only with its additional
handle.
For mounting, screw it in the thread on the gearbox housing and fix it tightly.
All manuals and user guides at all-guides.com
Electrical Connection
Cross section in sq. mm
1.5
20 m
50 m
16
2.5
40 m
80 m
Werbung
