Auto Search - Reflexion LED2223 Bedienungsanleitung

CHANNEL MENU SATELLITE
Satellite unicable setting
1. Press the [Menu] key.
2. Use the buttons [▲ ▼ ◄►] to navigate to the menu item "Sat configuration".
3. Confirm the entry with the [OK] key.
4. Press the [►] button and select the [LNB Type] item.
5. Press the [OK] key and navigate to "Unicable".
6. Press the [OK] key to confirm the selection.
7. The following setting options are available.
LNB low
LNB high
Channel ID
Frequency
CHANNEL MENU DTV (DVB-C/T)
1. Several channel-related menu items are available in the channel menu.
2. The available menu items depend on whether "Satellite" or "DTV" has been selected as
"Signal source".
3. The following menu items are available for the "DTV" area.

Auto Tuning / ATV Manual Tuning / DTV Manual Tuning / Programme Edit / Signal
Information / CI Information / 5V antenna power

Auto Search

For the menu item "Auto. Search" the following settings are available.
Country
Tune Type
DVB Select Type
Scan Type
Network ID
Frequency
Symbol Rate
LCN
Enter the lowest LNB frequency. The setting can be found on your
LNB
Enter the top LNB frequency. The setting can be found on your LNB.
Enter the channel ID. The setting can be found on your multi-switch or
LNB.
Enter the Unicable frequency. The frequency can be found on your
multiswitch or LNB.
Can not be adjusted
ATV + DTV / DTV / ATV
DVB-C / DVB-T
Network Scan / Full (only for DVB-C)
Only for DVB-C when the menu point „Scan Type" „Network scan"
is selected.
Only for DVB-C when the menu point „Scan Type" „Network scan"
is selected.
Only for DVB-C when the menu point „Scan Type" „Network scan"
is selected.
On / Off (It is recommended to set the setting to "Off")
48
UK