Kinderkraft TIK Bedienungsanleitung Seite 15

Thank you for purchasing a Kinderkraft product. Our products have been designed for your child's safety and comfort. The
buggy is an ideal solution for those who value quality, modernity and functionality. Please read the manual carefully and
follow its recommendations.
IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE
REFERENCE.
WARNING!
• Never leave the child unattended.
• Ensure that all the locking devices are engaged before use.
• To avoid injury ensure that the child is kept away when
unfolding and folding this product.
• Do not let the child play with this product.
• Check that the pram body or seat unit or car seat attachment
devices are correctly engaged before use.
• This product is not suitable for running or skating.
• This seat unit is not suitable for children under 6 months
• Always use the restraint system.
• Age and weight usage: from 6 months up to 15 kg
• This product may only be used by one child at the same time
• The maximum basket load is 2 kg.
• Any load attached to the handle and/or on the back of the backrest and/or on the sides of the vehicle will affect the
stability of the vehicle.
• Lift the front suspension when going up a curb or step.
• The parking device shall be engaged when placing and removing the children
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
I. STROLLER PARTS
1. Frame with seat and safety
harness
2. Front wheel x2
3. Rear wheel with axle x2
4. Canopy
II. ASSEMBLING/DETACHING THE WHEELS
To assemble the front wheels (2), slide them onto the tubes located in the frame until you hear a characteristic click (Fig. A).
Pay attention to the correct positioning of the wheels. The rear wheels with axle(3) should be clipped into the rear part of
the frame until you hear a characteristic click( Fig.B).
The front wheels have the ability to be locked in straight forward movement. Activate this function by pulling up the locking
lever (Fig.C). To unlock the front wheels, lower the lever to the starting position.
To remove the front wheels, push the lever inward and then slide the wheel out (Fig. D).
NOTE! Before using the buggy make sure that all the wheels are
properly installed.
III. UNFOLDING THE FRAME
Stand the frame on a flat surface, handle up. Start unfolding the stroller by releasing the blocking element on the right side
(Fig.E.I). Next, pull the handle upwards (Fig.E.II), unfold the stroller and lock it by moving the lever downwards (see Fig.F).
Dear Customers,
15