EINHELL GC-EC 2040 Originalbetriebsanleitung Seite 29

All manuals and user guides at all-guides.com
12. Troubleshooting
Danger!
Before troubleshooting, switch off the tool and disconnect the mains plug.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If the problem still persists after working through the list then please con-
tact your nearest service workshop.
Cause
Chainsaw does not - Quick stop brake has been trigge-
work at all
- No power supply
- Defective mains outlet
- Power extension cable damaged
- Defective fuse
Chainsaw operates - Power cable damaged
intermittently - Loose connection (external)
- Loose connection (internal)
- ON/OFF switch defective
Saw chain dry - No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
Chain brake does - Problem with the switch mecha-
not work
Chain/guide rail hot - No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Blunt chain
Chainsaw judde- - Chain tension too loose
ring, vibrating or not - Blunt chain
sawing properly - Worn chain
- Saw teeth pointing in the wrong
Anl_GC_EC_2040_SPK13.indb 29
GB
Fault
red
nism in the front hand guard
direction
- 29 -
Remedy
- Pull the hand protection back to the
normal position.
- Check the power supply.
- Try an alternative source of electri-
cal power, replace if necessary.
- Check the cable and replace as
required.
- Replace the fuse.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
29.06.2021 11:29:24